AbstractAbout AuthorsReferences
This article discusses issues related to correcting the adhesive properties of composite materials based on organic waste and expanded polystyrene. The theoretical prerequisites for the formation of the structure of materials based on organic raw materials are determined. An average series of binders has been established as the adhesive strength with vegetable filler increases. The results of determining the adhesive strength of polystyrene foam in the structure of the composite material are presented. In order to increase the hydrophilicity of polystyrene foam, such binders as polyvinyl acetate emulsion, liquid glass, and acrylic latex were used in research. Analysis of the results obtained allows us to evaluate the effectiveness of the binder and determine the optimal type of filler in the composition of the composite material, based on the values of the shear strength. As a result, it was found that the introduction of expanded polystyrene into the composition of a composite material based on organic raw materials makes it possible to reduce the consumption of the binder by 82–87% due to its treatment with an aqueous solution of dimethyl ketone and providing it with adhesive ability. Thus, it is possible to significantly increase the share of organic waste used in the production of building materials, increasing the efficiency of their processing and disposal.
O.E. SMIRNOVA, Candidate of Sciences (Engineering) (This email address is being protected from spambots. You need JavaScript enabled to view it.),
А.P. PICHUGIN, Doctor of Sciences (Engineering) (This email address is being protected from spambots. You need JavaScript enabled to view it.),
V.F. KHRITANKOV, Doctor of Sciences (Engineering) (This email address is being protected from spambots. You need JavaScript enabled to view it.)
А.P. PICHUGIN, Doctor of Sciences (Engineering) (This email address is being protected from spambots. You need JavaScript enabled to view it.),
V.F. KHRITANKOV, Doctor of Sciences (Engineering) (This email address is being protected from spambots. You need JavaScript enabled to view it.)
Novosibirsk State University of Architecture and Civil Engineering (SIBSTRIN) (113, Leningradskaya Street, Novosibirsk, 630008, Russian Federation)
1. Solomatov V.I., Vyrovoy V.N., Selyaev V.P. Polistrukturnaya teoriya kompozitsionnykh stroitel’nykh materialov [Polystructural theory of composite building materials]. Tashkent: Fan. 1991. 345 p.
2. Solomatov V.I. Development of the polystructural theory of composite building materials. Izvestiya of higher educational institutions. Construction. 1985. No. 8, pp. 58–64. (In Russian).
3. Ryb’ev I.A. Construction materials science. [Stroitel’noe materialovedenie]. Moscow: Yurayt. 2011. 700 p.
4. Bazhenov Yu.M. Achievements, problems and directions of development of the theory and practice of building materials science. Materials of the X Academic Readings of the RAACS. Penza, Kazan, 2006, pp. 3–7. (In Russian).
5. Bazhenov Yu.M. Basic approaches to computer modeling of building composites. Stroitel’nye Materialy [Construction Materials]. 2006. No. 7, pp. 2–4. (In Russian).
6. Chermashentsev V.M. Theoretical aspects of computer modeling of effective composite materials. Izvestiya of higher educational institutions. Construction. 2002. No. 3, pp. 33–40. (In Russian).
7. Kharitonov A.M. Study of the properties of cement systems using the method of structural simulation modeling. Stroitel’nye Materialy [Construction Materials]. 2008. No. 9, pp. 81–83. (In Russian).
8. Arbuzov V.V. Kompozitsionnyye materialy iz ligninnykh veshchestv. [Composite materials from lignin substances]. Moscow: Ecology, 1991. 209 p.
9. Nanazashvili I.Kh. Adhesion of early and late wood with cement stone. Trudy TsNIIEPsel’stroya. 1980. No. 7, pp. 79–84. (In Russian).
10. Zavadsky V.F. Determination of the tensile strength of expanded clay. Industry of ceramic wall materials and porous aggregates: Ref. inf. VNIIESM. 1982. Iss. 5, pp. 25–26. (In Russian).
11. Pichugin A., Pchelnikov A., Smirnova O., Tkachenko S. Influence of surface tension forces of modifiers on some properties of composite materials. Proceedings of the 6th International Conference on Construction, Architecture and Technosphere Safety. ICCATS 2022. Lecture Notes in Civil Engineering. 2023. Vol. 308. https://doi.org/10.1007/978-3-031-21120-1_26
12. Deryagin B.V., Krotova N.A., Smigla V.P. Adgeziya tverdykh tel [Adhesion of solids]. Moscow: Nauka, 1973. 278 p.
13. Pisarenko A.P., Pospelova K.A., Yakovlev A.G. Kurs kolloidnoi khimii [Colloid chemistry course]. Moscow: Higher School, 1964, 250 p.
14. Pichugin A.P., Khritankov V.F., Pchelnikov A.V., Smirnova O.E. Determination of adhesion of cement stone to polyethylene film in organomineral composites. Izvestiya of higher educational institutions. Construction. 2021. No. 5 (749), pp. 49–58. (In Russian).
2. Solomatov V.I. Development of the polystructural theory of composite building materials. Izvestiya of higher educational institutions. Construction. 1985. No. 8, pp. 58–64. (In Russian).
3. Ryb’ev I.A. Construction materials science. [Stroitel’noe materialovedenie]. Moscow: Yurayt. 2011. 700 p.
4. Bazhenov Yu.M. Achievements, problems and directions of development of the theory and practice of building materials science. Materials of the X Academic Readings of the RAACS. Penza, Kazan, 2006, pp. 3–7. (In Russian).
5. Bazhenov Yu.M. Basic approaches to computer modeling of building composites. Stroitel’nye Materialy [Construction Materials]. 2006. No. 7, pp. 2–4. (In Russian).
6. Chermashentsev V.M. Theoretical aspects of computer modeling of effective composite materials. Izvestiya of higher educational institutions. Construction. 2002. No. 3, pp. 33–40. (In Russian).
7. Kharitonov A.M. Study of the properties of cement systems using the method of structural simulation modeling. Stroitel’nye Materialy [Construction Materials]. 2008. No. 9, pp. 81–83. (In Russian).
8. Arbuzov V.V. Kompozitsionnyye materialy iz ligninnykh veshchestv. [Composite materials from lignin substances]. Moscow: Ecology, 1991. 209 p.
9. Nanazashvili I.Kh. Adhesion of early and late wood with cement stone. Trudy TsNIIEPsel’stroya. 1980. No. 7, pp. 79–84. (In Russian).
10. Zavadsky V.F. Determination of the tensile strength of expanded clay. Industry of ceramic wall materials and porous aggregates: Ref. inf. VNIIESM. 1982. Iss. 5, pp. 25–26. (In Russian).
11. Pichugin A., Pchelnikov A., Smirnova O., Tkachenko S. Influence of surface tension forces of modifiers on some properties of composite materials. Proceedings of the 6th International Conference on Construction, Architecture and Technosphere Safety. ICCATS 2022. Lecture Notes in Civil Engineering. 2023. Vol. 308. https://doi.org/10.1007/978-3-031-21120-1_26
12. Deryagin B.V., Krotova N.A., Smigla V.P. Adgeziya tverdykh tel [Adhesion of solids]. Moscow: Nauka, 1973. 278 p.
13. Pisarenko A.P., Pospelova K.A., Yakovlev A.G. Kurs kolloidnoi khimii [Colloid chemistry course]. Moscow: Higher School, 1964, 250 p.
14. Pichugin A.P., Khritankov V.F., Pchelnikov A.V., Smirnova O.E. Determination of adhesion of cement stone to polyethylene film in organomineral composites. Izvestiya of higher educational institutions. Construction. 2021. No. 5 (749), pp. 49–58. (In Russian).
For citation: Smirnova O.E., Pichugin А.P., Khritankov V.F. Adhesive strength in the structure of composite materials based on organic raw materials. Stroitel'nye Materialy [Construction Materials]. 2024. No. 5, pp. 17–21. (In Russian). DOI: https://doi.org/10.31659/0585-430X-2024-824-5-17-21
