Selection of Compositions of Ceramic Masses on the Basis of Screenings Processing of Waste Materials for The Production Ceramic Using Mathematical Planning Methods

In this paper, we consider the selection of the composition of ceramic masses for the production of large-format ceramic blocks based on technogenic raw materials of the coal series using methods of mathematical planning of the experiment. The possibility of replacement of classical clay raw materials for unconventional industrial materials coal number of Eastern Donbass (screenings of territorial), which are formed by PE-processing of territorial to extract coal. The reasons for the increase in such a wide interest in this technogenic raw material was the reduction of the base of high-quality clay raw materials, as well as a large number of accumulated waste materials. The compositions selected in the work with the use of screenings of waste materials showed that ceramic samples have high strength characteristics that meet the requirements of GOST 530–2012. Using methods of mathematical planning of the experiment allows you to fully evaluate and analyze the data obtained.

E.S. GAISHUN, Engineer (This email address is being protected from spambots. You need JavaScript enabled to view it.),
K.S. YAVRUYAN, Candidate of Sciences (Engineering) (This email address is being protected from spambots. You need JavaScript enabled to view it.),
I.A. SEREBRYANAYA, Candidate of Sciences (Engineering) (This email address is being protected from spambots. You need JavaScript enabled to view it.),
E.V. DEMENTIEVA, Engineer (This email address is being protected from spambots. You need JavaScript enabled to view it.),
A.S. GAISHUN, Bachelor (This email address is being protected from spambots. You need JavaScript enabled to view it.)

Don State Technical University (1, Gagarin Square, 344000, Rostov-on-Don, Russian Federation)

1. Yavruyan K.S., Kotlyar V.D., Gaishun Е.S., Okhotnaya A.S., Lotoshnikova E.A., Chanturiya K. High performance ceramic stones on the basis of by-products of waste heaps – screenings and coal slurry. E3S Web Conf. Innovative Technologies in Environmental Science and Education (ITESE-2019). 2019. Vol. 135. https://doi.org/10.1051/e3sconf/201913503017
2. Yavruyan K.S., Gaishun Е.S., Teryokhina Y. Comprehensive approach to the processing of east Donbass spoil tip. IEEE International Conference “Management of Municipal Waste as an Important Factor of ustainable Urban Development” (WASTE). 2018, pp. 22–24. DOI: 10.1109/WASTE.2018.8554158
3. Yavruyan Kh.S., Gayshun E.S., Kotlyar A.V. Features of compression molding of fine-disperse products of coal washing when producing ceramic brick. Stroitel’nye Materialy [Construction Materials]. 2017. No. 12, pp. 14–17.
4. Yavruyan Kh.S., Kotlyar V.D., Lotoshnikova Ye.O., Gaishun E.S. Investigation of medium-fraction materials processing of terriconics for production wall ceramic products. Stroitel’nye Materialy [Construction Materials]. 2018. No. 4, pp. 17–20. DOI: https://doi.org/10.31659/0585-430X-2018-758-4-17-20 (In Russian).
5. Yavruyan Kh.S., Kotlyar V.D., Gaishun E.S. Complex processing of coal dumps of the Eastern Donbass for obtaining construction. Naukoemkie tekhnologii razrabotki i ispol’zovaniya mineral’nykh resursov. 2019. No. 5, pp. 489–494. (In Russian).
6. Gaishun E.S., Yavruyan Kh.S., Gaishun A.S. Technogenic raw materials of the coal row for the production of rough building ceramics. Aktual’nye problemy nauki i tekhniki. 2019, pp. 762–763. (In Russian).
7. Stolboushkin A.Yu., Ivanov A.I., Fomina O.A. Use of coal-mining and processing wastes in production of bricks and fuel for their burning. Procedia Engineering. 2016. Vol. 150, pp. 1496–1502. https://doi.org/10.1016/j.proeng.2016.07.089
8. Stolbushkin A.Yu., Akst D.V., Fomina O.A., Ivanov A.I., Syromyasov V.A. Analysis of coal industry waste from enterprises of the Kemerovo region as a raw material for the production of ceramic materials. IOP Conference Series: Earth and Environmental Science. 2017.
9. Yavruyan K.S., Kotlyar V.D., GaishunE.S. Medium-fraction materials for processing of coal-thread waste drains for the production of wall ceramics. Materials Science Forum. 2018. Vol. 931, pp. 532–536. https://doi.org/10.4028/www.scientific.net/MSF.931.532
10. Yavruyan K.S., Kotlyar V.D. Thin issues products of processing waste heaps as raw materials for ceramic wall products. MATEC Web of Conferences. 2017. 05013. https://doi.org/10.1051/matecconf/201712905013
11. Terekhina Yu.V., Lapunova К.А., Kotlyar А.V., Orlova М.Е., Lazareva Ya.V., Yaschenko R.A., Bozhko Yu.A. Methods for testing stonelike siliceous and clay raw materials used for producing ceramic. Atlantis Highlights in Material Sciences and Technology (AHMST). 2019. Vol. 1, рр. 328–332. https://doi.org/10.2991/isees-19.2019.64
12. Serebryanaya I.A., Matrosov A.A., Poryadina N.A., Soloviev A.N. Analysis of the stress-strain state of ceramic brick when tested for compressive strength. Materials Science Forum. 2020. Vol. 974, pp. 510–514. https://doi.org/10.4028/www.scientific.net/MSF.974.510
13. Matrosov A.A., Nizhnik D.A., Poryadina N.A., Serebryanaya I.A., Soloviev A.N. Calculation of stresses and deformations in masonry with various types of bricks. Proceedings of the 2018 International Conference on «Physics, Mechanics of New Materials and Their Applications». 2019, pp. 243–249. https://novapublishers.com/shop/proceedings-of-the-2018-international-conference-on-physics-mechanics-of-new-materials-and-their-applications/
14. Nizhnik D.A., Serebryanaya I.A., Poryadina N.A. Investigation of the stress-strain state of ceramic bricks of various voids during a compression test. XII All-Russian Congress on Fundamental Problems of Theoretical and Applied Mechanics: a collection of works in 4 volumes. Vol. 3: Mechanics of a Deformable Solid. Ufa: RITs BashGU, 2019, pp. 156–157. (In Russian).
15. Muñoz Velasco P., Morales Ortíz M.P., Medívil Giró M.A., Muñoz Velasco L. Fired clay bricks manufactured by adding wastes as sustainable construction material – A review. Construction and Building materials. 2014. Vol. 63, pp. 97–107. https://doi.org/10.1016/j.conbuildmat.2014.03.045
16. Livadnaya D.B., Serebryanaya I.A. Analysis of the causes and consequences of potential inconsistencies in the construction industry. Inzhenernyi vestnik Dona. 2019. No. 6. (In Russian).
17. Nizhnik D.A., Poryadina N.A., Serebryanaya I.A Mathematical and computer modeling in ANSYS of elements of building structures with different structures of porosity. Mathematical modeling and biomechanics in a modern university: Abstracts of the XIV All-Russian School. May 27–31, 2019. Rostov-on-Don, Taganrog. p. 108. (In Russian).
18. Poryadina N.A., Serebryanaya I.A. Mathematical modeling of testing of ceramic bricks for compressive strength. Mathematical modeling and biomechanics in a modern university: Abstracts of the XIV All-Russian School. May 27–31, 2019. Rostov-on-Don, Taganrog. 2019, p. 116. (In Russian).
19. Serebryanaya I.A., Serebryanaya D.S. Mathematical planning in the selection of the composition of building materials. Intelligent technologies and problems of mathematical modeling: Proceedings of the II All-Russian Scientific Conference. September 30 – October 3, 2019. Rostov-on-Don, pp. 42–43. (In Russian).
20. Poryadina N.A., Matrosov A.A., Serebryanaya I.A., Nizhnik D.A. Mathematical modeling of conditions for testing ceramic bricks. Intelligent technologies and problems of mathematical modeling: Proceedings of the II All-Russian Scientific Conference. September 30 – October 3, 2019. Rostov-on-Don, pp. 41–42. (In Russian).