knauf b1


Production of Silicate Materials with Addition of Fine-Ground Open-Hearth Furnace Slag

Number of journal: 8-2019
Autors:

Stolboushkin A.Yu.

DOI: https://doi.org/10.31659/0585-430X-2019-773-8-26-32
УДК: 666.965.4

 

AbstractAbout AuthorsReferences
The necessity of expanding the local raw material base for the production of silicate building materials due to anthropogenic alumino-silicate raw materials is shown. The chemical-mineralogical composition and the possibility of fine grinding of open-hearth furnace slag of steelmaking are investigated. The major mineral phases of the slag are melilite, kirschsteinite, magnesioferrite, wustite, periclase and forsterite. According to the sieve analysis it was found that 50–58% of the slag falls on the fraction of more than 5 mm. The optimal parameters of two-stage slag grinding, including coarse crushing to a fraction of less than 10 mm and fine grinding for 50–60 minutes to a fraction of 100–300 microns are determined. By chemical composition (about 50% of alkaline earth oxides) and the presence of hydraulically active minerals it is proposed to use the slag as the main component of lime-silica binder in the technology of silicate bricks. The influence of the addition of fine slag in the autoclave binder on the physical and mechanical properties of silicate samples was revealed. It is established that the introduction of 15–25% of crushed open-hearth furnace slag instead of calcium air lime into the autoclave binder composition provides an increase in the compressive strength of silicate samples by 15–20%. The optimum composition of the autoclaved binder with the use of a finely ground open-hearth furnace slag which provides the strength of silicate compacted material not below 25–30 MPa is experimentally established.
A.Yu. STOLBOUSHKIN, Doctor of Sciences (Engineering) (This email address is being protected from spambots. You need JavaScript enabled to view it.)

Siberian State Industrial University (42, Kirova Street, Novokuznetsk, 654007, Russian Federation)

1. Russian Market of Ceramic Wall Materials in 2016. Stroitel’nye Materialy [Construction Materials]. 2017. No. 4, pp. 4–5. (In Russian).
2. Gagarin V.G., Kozlov V.V. Requirements for thermal protection and energy efficiency in the draft of the updated SNiP «Thermal Protection of Buildings». Zhilishchnoe stroitel’stvo [Housing Construction]. 2011. No. 8, pp. 2–6. (In Russian).
3. Semenov A.A. Trends in development of brick industry and brick housing construction in Russia. Stroitel’nye Materialy [Construction Materials]. 2018. No. 8, pp. 49–51. DOI: https://doi.org/10.31659/0585-430X-2018-762-8-49-51 (In Russian).
4. State report «About the state and environmental protection of the Russian Federation in 2009». Russian Federation. Ministry of Natural Resources and Ecology. Moscow: Minprirody of Russia. 2010. http://www.mnr.gov.ru/upload/iblock/2b1/6158_osdoklad_-2009.zip (дата обраще-ния 25.04.2019). (In Russian).
5. Petrov I.V., Savon D.Yu. Ecological and economic approach in the field of waste management in the region. Ecology. Nature management. Economics: Proceedings of the Moscow State University for the Humanities. Moscow: MSMU. 2013. pp. 43–56. (In Russian).
6. Lyashenko V.I., Dyatchin V.Z. Environmental protection in the regions of ore mining and processing. Ekologiya proizvodstva. 2013. No. 3, pp. 56–59. (In Russian).
7. Rakhimov R.Z., Magdeev U.Kh., Yarmakovsky V.N. Ecology, scientific achievements and innovations in the production of building materials based on and with the use of technogenic raw materials. Stroitel’nye Materialy [Construction Materials]. 2009. No. 12, pp. 8–11. (In Russian).
8. There are two plants of the full metallurgical cycle in Novokuznetsk city. Municipal website of the city of Novokuznetsk. Section 17. Ecological situation in the city of Novokuznetsk. Characteristics of air pollution. 2019. http://admnkz.ru/actionDocument.do?id=51922. (Date of access 25.04.2019).
9. Mamaev K.A., Mitrofanov A.M. Osnovy agrohimii i primenenie yadohimikatov [Fundamentals of agrochemistry and chemical pesticides appliance]. Moscow: Vysshaya shkola. 1975. 168 p.
10. Evtushenko E.I. Kompleksnaya pererabotka metallosoderzhashchih othodov [Complex processing of metal-containing waste]. Belgorod: BelGATASM. 1996. 60 p.
11. Lesovik V.S., Sheychenko M.S., Alfimova N.I. Composite binders using high magnesian waste from the Kovdorsky deposit. Vestnik of BSTU named after V.G. Shukhov. 2011. No. 1, pp. 10–14. (In Russian).
12. Panfilov M.I. et al. Kompleksnaya pererabotka metallosoderzhashchih othodov [Slag processing and waste-free technology in metallurgy]. Moscow: Metallurgiya. 1987. 238 p.
13. Khobotova E.B., Kalmykova Yu.S. Ecological and chemical justification for the disposal of waste blast furnace slag in the production of binders. Ekologicheskaya himiya. 2012. No. 21 (1), pp. 27–37. (In Russian).
14. Shapovalov N.A., Zagorodniuk L.Kh., Tikunova I.V., Shekina A.Yu. Rational ways of using steelmaking slag. Fundamental’nye issledovaniya. Tekhnicheskie nauki. 2013. No. 1, pp. 439–443. (In Russian).
15. Shevchenko V.V., Akst D.V., Stolboushkin A.Yu. Investigation of dump open-hearth slag before and after activation in a rod-type mill to obtain building materials. Prospects for the development of basic sciences: Materials of the XIV international conference of students, graduate students and young scientists. Tomsk: TPU. 2017. pp. 77–79. (In Russian).
16. Perepelitsyn V.A. Osnovy tekhnicheskoj mineralogii i petrografii [Fundamentals of technical mineralogy and petrography]. Moscow: Nedra. 1987. 256 p.

For citation: Stolboushkin A.Yu. Production of silicate materials with addition of fine-ground open-hearth furnace slag. Stroitel’nye Materialy [Construction Materials]. 2019. No. 8, pp. 26–32. (In Russian). DOI: https://doi.org/10.31659/0585-430X-2019-773-8-26-32


Print   Email