About Production of High-Quality Cubiform Crushed Stone

Number of journal: №7-2017
Autors:

Shuloyakov A.D.

DOI: https://doi.org/10.31659/0585-430X-2017-750-7-56-59

AbstractAbout AuthorsReferences
It is shown that the volume of crushed stone consumption as a main component for road construction and production of building structures made of concrete are constantly growing both in Russia and the whole world. At that, requirements for the quality of products, cost efficiency and sustainability of the production are increased. One of the new requirements for crushed stone is a minimal content of platelet-shaped and needle-shaped grains. A comparative analysis of technical characteristics of various crushing units and techniques on their basis for producing the cubiform crushed stone is presented. It is shown that the most efficient units for producing the cubiform crushed stone are cone inertial crushers developed at Research and Engineering Corporation “Mekhanobrtekhnika”. The scientific basis of vibration crushing technique is revealed. Examples of the successful operation of the cone inertial crushers and vibrating screens at the enterprises of Kazakhstan, where two-stage and one-stage crushing schemes were realized, are presented.
A.D. SHULOYAKOV, Candidate of Sciences (Engineering) (This email address is being protected from spambots. You need JavaScript enabled to view it.)

OOO «Interstroyproekt» (128A, Nevsky Prospect, 191036, Saint-Petersburg, Russian Federation)

1. Butkevich G.R. View of the future of non-metallic building materials industry. Stroitel’nye Materialy [Construction Materials]. 2014. No. 9, pp. 48–51. (In Russian).
2. Dubov V.A., Larina V.F., Levchenko I.P. Technology of production of high-quality fine gravel. Stroitel’nye Materialy [Construction Materials]. No. 3, pp. 17–18. (In Russian).
3. Vaysberg L.A., Zarogatskiy L.P. New equipment for crushing and grinding materials. Gornyi zhurnal. 2000. No. 3, pp. 49–52. (In Russian).
4. Vaysberg L.A., Zarogatskiy L.P. New generation of jaw and cone crushers. Stroitel’nye i dorozhnye mashiny. 2000. No. 7, pp. 16–21. (In Russian).
5. Arsent’ev V.A., Vaysberg L.A., Zarogatskiy L.P., Shuloyakov A.D. Proizvodstvo kubovidnogo shchebnya i stroitel’nogo peska s ispol’zovaniem vibratsionnykh drobilok[Production of cube-shaped crushed stone and building sand using vibrating crushers]. Saint Petersburg: VSEGEI Publishing house. 2004. 112 p.
6. Vaysberg L.A., Shuloyakov A.D., Orlov S.L., Spiridonov P.A., Dalatkazin A.A New technologies for the production of high-quality crushed stone of fine fractions. Gornaya promyshlennost’. 2010. No. 3 (91), pp. 10. (In Russian).
7. Vaysberg L.A., Shuloyakov A.D., Spiridonov P.A. Reduction of the stage of crushing is the best way to reduce the cost of high-quality crushed stone. Stroitel’nye Materialy [Construction Materials]. 2002. No. 11, pp. 7–9. (In Russian).
8. Bukaty G.B., Vaisberg L.A., Gol’dina T.Yu., Leonov B.P., Reineke K.F., Ryskin M.Ya., Shelestov M.S. On the use of a grid-like grids on screens in closed-cycle crushing schemes. Tsvetnye metally. 1984. No. 8, pp. 103–105. (In Russian).

For citation: Shuloyakov A.D. About production of high-quality cubiform crushed stone. Stroitel’nye Materialy [Construction Materials]. 2017. No. 7, pp. 56–59. (In Russian).


Print   Email