AbstractAbout AuthorsReferences
Results of the 2015 in the production of autoclaved aerocrete (AA) are summarized. It is shown that under the conditions of economic recession the industry continues to develop. In 2015 production capacity for the production of AA increased and equals to 18.6 mln m3. It become possible due to the opening of new production facilities (4 factories) and modernization of operating enterprises. The manufacture of AA exceeded 13 mln m3 that by 0.97% higher than in 2014. Enterprises started to manufacture lighter, more heat efficient products. The index of average density of all produced in 2015 is 514.1 kg/m3 , a year earlier this index was 516.7 kg/m3. However, under conditions of the declining demand for building materials the capacity utilization rate decreased by average 7.1%. Releases prices for autoclaved aerocrete also reduced up to the level of 2013. This led to decrease in the profitability of production. Under the current economic conditions several enterprises were closed. A slight increase in output is predicted in 2016 (13.5 mln m3) that demonstrates the certain optimism of market participants regarding the existing situation. The realization of these forecasts will depend on the current economic situation, more precise forecasts can be made on the basis of results of the first half of 2016.
A.A. VISHNEVSKIY1 , Candidate of Sciences (Engineering) (This email address is being protected from spambots. You need JavaScript enabled to view it.);
G.I. GRINFELD2 , (This email address is being protected from spambots. You need JavaScript enabled to view it.), Executive Director,
A.S. SMIRNOVA2 , Assistant of Executive Director
G.I. GRINFELD2 , (This email address is being protected from spambots. You need JavaScript enabled to view it.), Executive Director,
A.S. SMIRNOVA2 , Assistant of Executive Director
1 Ural Federal University named after the First President of Russia B.N. Yeltsin (19 Mira Street, Ekaterinburg, 620002 Russian Federation)
2 National Association of Autoclaved Aerocrete Manufacturers (40A Oktyabrskaya Embankment, Saint-Petersburg, 193091, Russian Federation)
1. Grinfel’d G.I. Production of Autoclave Gas Concrete in Russia: State of Market and Prospects of Development. Stroitel’nye Materialy [Construction Materials]. 2013. No. 2, pp. 76–78. (In Russian).
2. Vishnevsky A.A., Grinfel’d G.I., Kulikova N.O. Analysis of Autoclaved Aerated Concrete Market of Russia. Stroitel’nye Materialy [Construction Materials]. 2013. No. 7, pp. 40–44. (In Russian).
3. Vishnevskij A.A., Grinfel’d G.I., Smirnova A.S. Results of work of the enterprises for production of autoclave cellular concrete in 2013. Tehnologii betonov. 2014. No. 4, pp. 44–47. (In Russian).
4. Vishnevsky A.A., Grinfel’d G.I., Smirnova A.S. Production of Autoclaved Aerated Concrete in Russia. Stroitel’nye Materialy [Construction Materials]. 2015. No. 6, pp. 52–54. (In Russian).
2. Vishnevsky A.A., Grinfel’d G.I., Kulikova N.O. Analysis of Autoclaved Aerated Concrete Market of Russia. Stroitel’nye Materialy [Construction Materials]. 2013. No. 7, pp. 40–44. (In Russian).
3. Vishnevskij A.A., Grinfel’d G.I., Smirnova A.S. Results of work of the enterprises for production of autoclave cellular concrete in 2013. Tehnologii betonov. 2014. No. 4, pp. 44–47. (In Russian).
4. Vishnevsky A.A., Grinfel’d G.I., Smirnova A.S. Production of Autoclaved Aerated Concrete in Russia. Stroitel’nye Materialy [Construction Materials]. 2015. No. 6, pp. 52–54. (In Russian).
For citation: