Analysis of the Destruction Kinetics of Nanomodified High-Strength Lightweight Concrete by Acoustic Emission

Number of journal: №1-2-2016
Autors:

A.S. INOZEMTCEV
E.V. KOROLEV

DOI: https://doi.org/10.31659/0585-430X-2016-733-734-1-2-38-47
УДК: 620.19:666.973:620.171.2

 

AbstractAbout AuthorsReferences
The paper presents the experimental data and analysis of the dependence of energy of acoustic emission on the physical and mechanical properties of high-strength lightweight concrete filled hollow ceramic microspheres. Shown that the kinetics of acoustic emission energy of the studied concrete can be described in three stages with different intensity and duration. The introduction of hollow ceramic microspheres into fine-grained sand concrete up to some limit (not more than 18% by weight) allows the formation of composite structure with longer «safety stage», when acoustic emission energy varies with the lowest intensity at increasing the load. The duration of this stage depends on the mechanical properties of lightweight aggregate, cement-mineral matrix and strength of their mutual coupling. The hardening of the phase boundary between the filler and cement-mineral matrix will reduce the defectiveness of the structure of high-strength lightweight concrete with high content of hollow microspheres. Analysis of the destruction of high-strength lightweight concrete by the acoustic emission method allows to determine the dependences of structure conversion when using nanoscale modifier and identify the limit of the formation the conditions for the smallest defects in material. Shown that the greatest effect of the application of nanomodifier is observes for the compositions with average density less than 1500 kg/m3 . It is expressed as an increase in the relative change in the compressive strength and the changing the nature of the recorded parameters of acoustic emission. The acoustic emission method is an effective method to study the influence of nanoscale additives on the structure and properties of construction materials.
A.S. INOZEMTCEV, Candidate of Sciences (Engineering) (This email address is being protected from spambots. You need JavaScript enabled to view it.),
E.V. KOROLEV, Doctor of Sciences (Engineering), Director Research and Education

Center «Nanomaterials and Nanotechnology», Advisor RAACS (This email address is being protected from spambots. You need JavaScript enabled to view it.) Moscow State University of Civil Engineering (National Research University) (26, Yaroslavskoe Highway, Moscow, 129337, Russian Federation)

1. Pashkevich S., Pustovgar A., Adamtsevich A., Eremin A. Pore structure formation of modified cement systems, hardening over the temperature range from +22оC to -10оC. Applied Mechanics and Materials. 2014. Vol. 584–586, pp. 1659–1664.
2. Adamtsevich A.O., Pustovgar A.P. Features of influence of modifying additives on the kinetics of hardening cement systems. Sukhie stroitel’nye smesi. 2015. No. 4, pp. 26–29. (In Russian).
3. Adamtsevich A., Eremin A., Pustovgar A., Pashkevich S., Nefedov S. Research on the effect of prehydration of portland cement stored in normal conditions. Applied Mechanics and Materials. 2014. Vol. 670–671, pp. 376–381.
4. Shahidana S., Pulinb К., Bunnoric N.M., Holfordb K.M. Damage classification in reinforced concrete beam by acoustic emission signal analysis. Construction and Building Materials. 2013. Vol. 45, pp. 78–86.
5. Maksimova I.N., Makridin N.I., Surov I.A. Methodological aspects of forecasting the mechanical behavior of cement composites. Regional’naya arkhitektura i stroitel’stvo. 2014. No. 3, pp. 37–41. (In Russian).
6. Selyaev V.P., Danilov A.M., Kruglova A.N. Evaluation of the properties of modified epoxy composites by acoustic emission. Regional’naya arkhitektura i stroitel’stvo. 2013. No. 1, pp. 67–74. (In Russian).
7. Carpinteria A., Lacidognaa G., Accorneroa F., Mpalaskasb A.C., Matikasb T.E., Aggelisc D.G. Influence of damage in the acoustic emission parameters. Cement and Concrete Composites. 2013. Vol. 44, pp. 9–16.
8. Guzmana C., Torresa D., Hucailuka C., Filipussia D. Analysis of the acoustic emission in a reinforced concrete beam using a four points bending test. Procedia Materials Science. 2015. Vol. 8, pp. 148–154.
9. Makridin N.I., Korolev E.V., Maksimova I.N. Acoustic emission in building materials. Stroitel’nye Materialy [Construction Materials]. 2007. No. 3, pp. 100–103. (In Russian).
10. Ushakov S.I. Micro cracking in epoxy polymer concrete compressive. Vestnik Volgogradskogo gosudarstvennogo arkhitekturno-stroitel’nogo universiteta. Seriya: Stroitel’stvo i arkhitektura. 2010. No. 1 (17), pp. 28–33. (In Russian).
11. Perfilov V.A. Control of deformation and fracture of concrete methods of fracture mechanics and acoustic emission. Vestnik Volgogradskogo gosudarstvennogo arkhitekturno-stroitel’nogo universiteta, Seriya. Stroitel’stvo i arkhitektura. 2014. No. 38 (57), pp. 75–84. (In Russian).
12. Aggelisa D.G., Mpalaskasb A.C., Matikasb T.E. Investigation of different fracture modes in cement-based materials by acoustic emission. Cement and Concrete Research. 2013. Vol. 48, pp. 1–8.
13. Volkov V.V., Belykh A.G., Burakov A.V. Frost resistance of concrete and communication parameters of acoustic emission to the processes of cracking it. Tekhnologii betonov. 2012. No. 5–6, pp. 54–56. (In Russian).
14. Makridin N.I., Tarakanov O.V., Maksimova I.N., Surov I.A. Fracture mechanics of sand concrete and fiber-reinforced concrete. Izvestiya Kazanskogo gosudarstvennogo arkhitekturno-stroitel’nogo universiteta. 2014. No. 3, pp. 122–126. (In Russian).
15. Proshin A.P., Bozh’ev N.V., Fokin G.A., Smirnov V.A. Acoustic emission study of the destruction of radiation protection composite materials. Izvestiya vysshikh uchebnykh zavedenii. Stroitel’stvo. 2004. No. 1, pp. 20–23. (In Russian).
16. Patent RF 2472145. Ustroistvo dlya akustiko-emissionnogo kontrolya kompozitsionnykh materialov [A device for acoustic emission monitoring of composite materials] / Smirnov V.A., Korolev E.V.; Declared 23.09.2011. Published 10.01.2013. Bulletin No. 1. (In Russian).
17. Patent RF 2515450. Vysokoprochnyi legkii beton [Highstrength lightweight concrete] / Korolev E.V., Inozemtcev A.S.; Declared 11.10.2012. Published 10.05.2014. (In Russian).
18. Korolev E.V., Smirnov V.A., Albakasov A.I., Inozemtcev A.S. Some aspects of the design of multicomponent composite materials. Nanotekhnologii v stroitel’stve: nauchnyi internet-zhurnal. 2011. No. 6, pp. 32–43. (In Russian).
19. Inozemtcev A.S. The average density and porosity of the high-strength lightweight concrete. Inzhenerno-stroitel’nyi zhurnal. 2014. No. 7 (51), pp. 31–37. (In Russian).
20. Grishina A.N., Korolev E.V. Zhidkostekol’nye stroitel’nye materialy spetsial’nogo naznacheniya [Liquid-glass building materials, special purpose]. Moscow.: MSUCE. 2015. 224 p.
21. Ziehl P., Pollock A. Acoustic Emission for Civil Structures. Acoustic Emission. InTech. 2012. 396 p.
22. Inozemcev A.S. High-strength lightweight concrete mixtures based on hollow microspheres: technological features and industrial experience of preparation. IOP Conference Series: Materials Science and Engineering. 2015. Vol. 71. Iss. 1. 012028. doi: 10.1088/1757- 899X/71/1/012028.
23. Inozemtcev A.S., Korolev E.V. A method for the reduction of deformation of high-strength lightweight cement concrete. Advances in Cement Research. 2015, pp. 1–7. doi: 10.1680/jadcr.15.00049.

For citation: 


Print   Email